EV Charger Installation

We recommend level 2 charger, 50amp, which is on it’s own dedicated circuit so that it has a dedicated place to pull power from. This prevents problems with existing power pull.

Yes, you need a permit for a Level 2 EV charger installation. Permits ensure compliance with electrical codes and safety standards. Always check local regulations or consult a local electrician. Tel: +1 (360) 907-3412

Charging times vary based on the charger’s power level:​

• Level 1 (120V): Provides about 3-5 miles of range per hour; a full charge can take over 24 hours.​

• Level 2 (240V): Delivers approximately 25 miles of range per hour; a full charge typically takes 4–7 hours.​ Energy.gov

• DC Fast Charging (480V+): Can add up to 200 miles of range in about 30 minutes.

Installation costs depend on factors like existing electrical infrastructure and charger type:​

• Equipment: Home chargers typically cost between $500 and $700.​

• Installation: Basic installations may cost between $200 and $500. However, if electrical upgrades are necessary, costs can increase by $1,000 to $1,500.

As of April 2025, the costs associated with installing electric vehicle (EV) charging stations continue to vary based on charger type, installation complexities, and site-specific factors. While precise cost projections for 2025 are limited, current data from the U.S. Department of Energy’s Alternative Fuels Data Center (AFDC) provides the following estimates:​

• Level 2 Chargers: Equipment costs typically range from $600 to $12,660 per unit. Installation expenses can vary depending on factors such as site preparation, electrical upgrades, and labor costs. ​

• DC Fast Chargers (Level 3): Equipment costs can range from $8,500 to $50,000 per unit. Installation costs are influenced by factors like charger power, number of chargers installed, and site-specific requirements. ​Alternative Fuels Data Center

To install a home EV charger:

1. Assess Electrical Capacity: Ensure your home’s electrical system can support the charger’s power requirements.

2. Obtain Necessary Permits: Secure any required permits from your local building authority.

3. Hire a Licensed Electrician: Find a professional to install the charger, as it will ensure compliance with safety standards and local codes. Tel: +1 (360) 907-3412

4. Inspection: After installation, have the work inspected as required by local regulations.Alternative Fuels Data Center

An EV charger is a heavy load. Some inspectors are saying, you need to do a load calculation on your home before you can add this EV charger to your system. If you are looking to do more than one, you most likely have to do a proper calculation of load. You must go through your appliances, square footage, and then add the desired EV and see if it’s below your 200amp load.